Campbell CS650, Руководство пользователя

Страница: 24 / 56

CS650 and CS655 Water Content Reflectometers
12
SDI12Recorder ( Destination , OutString , Multiplier , Offset )
For the other CRBasic dataloggers, the SDI12Recorder() instruction has the
following syntax:
SDI12Recorder (
Destination, SDIPort, SDIAddress, “SDICommand”, Multiplier,
Offset )
8. Operation
8.1 A200 and Device Configuration Utility
The A200 Sensor-to-PC Interface allows communication between a CS650 and a
PC, allowing sensor settings to be changed through
Device Configuration Utility
( DevConfig ) software.
8.1.1 Using the A200
8.1.1.1 Driver Installation
If the A200 has not been previously plugged into your PC and your PC operating
system is not Windows 7, the A200 driver needs to be loaded onto your PC.
Drivers should be loaded before plugging the A200 into the PC.
The A200 drivers can be downloaded, at no charge, from:
www.campbellsci.com/downloads .
8.1.1.2 RS-232 Wiring
One end of the A200 has a terminal block while the other end has a type B female
USB port. The terminal block provides 12V, G, Tx, and Rx terminals for
connecting the sensor (see Figure
8-1 and Table 8-1 ).
Figure 8-1. A200 Sensor-to-PC Interface
A data cable, pn #17648, ships with the A200. This cable has a USB type-A male
connector that attaches to a PC’s USB port, and a type B male connector that
attaches to the A200’s USB port.
NOTE