CRVW3 3-Channel Vibrating-Wire Datalogger
86
To add CRVW3 devices that are reached through a CRVW3 repeater station,
click on the CRVW3 device that has been configured as a repeater station and
press
Add
. Choose
CRVWSeries
from the datalogger list and press
Close
.
Now you have a CRVW3 device showing up as a child device of the CRVW3
repeater. This will instruct
LoggerNet
to route through the CRVW3 repeater to
get to the CRVW3 child device. Rename the device, configure it and press
Apply
. Multiple CRVW3 child devices can be added to any CRVW3
repeater/parent. Configure these devices using the tab screens in the same way
as the other CRVW3 devices were configured.
If you have a dedicated repeater station that is configured as a PakBus router
station, you should click on the
PakBusPort
device, and press
Add
. Select
pbRouter
and press
Close
. Enter the
PakBus Address
of the PakBus
router/repeater and press
Apply
. Now you can click on the
pbRouter
device
and press
Add
to add stations that route through this repeater. Choose
CRVWSeries
from the datalogger list and press
Close
. Rename the device,
configure it, and press
Apply
.
If a dedicated repeater station is not configured as a PakBus router, you should
add the CRVW3 devices reached through that repeater to the
PakBusPort
as
described above.
Once you can successfully check the clock on all of your CRVW3 devices, you
(p. 86)
10.7.3 Connecting to CRVW3 Stations
Use the
Connect Screen
to connect to each CRVW3 station and confirm that it
is communicating and operating correctly. Click on the green chain-link icon
from the
Main
category of the
LoggerNet
toolbar to open the
Connect Screen
.
Содержание CRVW3
