Campbell CRVW3, Инструкция по эксплуатации

Страница: 36 / 135

CRVW3 3-Channel Vibrating-Wire Datalogger
23
8.1.5 Configuring the CRVW3
Once you have successfully connected to the CRVW3 using DevConfig (see
above), you can configure the device. This is an important installation activity
that cannot be overlooked. Key settings must be configured before (or when) a
device is deployed to the field.
Use the Settings Editor tab that is available when DevConfig is connected to
make configurations to the CRVW3. The following sub-tabs will appear:
Main , PakBus , Channel 1 , Channel 2 , and Channel 3 . CRVW3 devices with
embedded radios will have Radio , and Radio Power Schedule tabs. The
–RF451 option will also have a Radio Advanced tab.
Key settings whose values you should review and set are listed below. As you
place the cursor in the box for each setting, the frame in the lower right corner
of the DevConfig screen shows text that describes the setting and how it is used
(online help).
8.1.5.1 Key Settings
[TabName – SettingName]
Main – Station Name
You can give a name to each CRVW3 station and store it in the device. When
planning a network of multiple devices, station naming can assist you in the
organization of your system. (See Planning your Network in Section 10.2 ,
Planning the Radio Network
(p. 62)
.)
Main – Measurement Interval
This setting specifies how often the CRVW3 should measure the sensors
connected to its active channels. The CRVW3 will repeatedly and
automatically make these measurements at this interval and store the results
until powered down, or re-configured.