Campbell CR6 Series, Руководство оператора

Страница: 234 / 690

Section 7. Installation
234
7.7.1.2 Conditional Output
CRBasic example Conditional Output
(p. 234)
demonstrates conditionally sending
data to a data table based on a trigger other than time.
Conditional Output
'This program example demonstrates the conditional writing of data to a data table. It
'also demonstrates use of StationName() and Units instructions.
'Declare Station Name (saved to Status table)
StationName (Delta_Temp_Station)
'Declare Variables
Public PTemp_C, AirTemp_C, DeltaT_C
'Declare Units
Units PTemp_C = deg C
Units AirTemp_C = deg C
Units DeltaT_C = deg C
'Declare Output Table -- Output Conditional on Delta T >=3
'Table stores data at the Scan rate (once per second) when condition is met
'because DataInterval instruction is not included in the table declaration
'after the DataTable declaration.
DataTable (DeltaT,DeltaT_C >= 3,-1)
Sample (1,Status.StationName,String)
Sample (1,DeltaT_C,FP2)
Sample (1,PTemp_C,FP2)
Sample (1,AirTemp_C,FP2)
EndTable
BeginProg
Scan (1,Sec,1,0)
'Measure wiring panel temperature
PanelTemp (PTemp_C,60)
'Measure type T thermocouple
TCDiff (AirTemp_C,1,mV200C,U1,TypeT,PTemp_C,True,0,60,1,0)
'Calculate the difference between air and panel temps
DeltaT_C = AirTemp_C - PTemp_C
'Call data table(s)
CallTable (DeltaT)
NextScan
EndProg
7.7.1.3 Groundwater Pump Test
CRBasic example Groundwater Pump Test
(p. 235)
shows how to do the following:
• Write multiple-interval data to the same data table
• Use program control instructions outside the Scan() / NextScan structure