Campbell CR3000 Micrologger, Руководство оператора

Страница: 555 / 644

Section 11. Glossary
555
Term: send
Send button in datalogger support software
(p. 90).
Sends a CRBasic program
or operating system to a CR3000.
Term: serial
A loose term denoting output of a series of ASCII, HEX, or binary characters
or numbers in electronic form.
Term: Settings Editor
An editor for observing and adjusting CR3000 settings. Settings Editor is a
feature of LoggerNet | Connect, PakBusGraph, and Device Configuration
Utility (DevConfig).
Term: Short Cut software
A CRBasic program wizard suitable for many CR3000 applications.
Knowledge of CRBasic is not required to use Short Cut. It is available at no
charge at www.campbellsci.com.
Term: SI (Système Internationale)
The uniform international system of metric units. Specifies accepted units of
measure.
Term: signature
A number which is a function of the data and the sequence of data in
memory. It is derived using an algorithm that assures a 99.998% probability
that if either the data or the data sequence changes, the signature changes.
See sections Security — Overview
(p. 88)
and Signatures
(p. 442).
Term: simplex
A serial communication protocol. One-direction data only. Serial
communications between a serial sensor and the CR3000 may be simplex.
Reading list: simplex
(p. 555),
duplex
(p. 307),
half duplex
(p. 541),
and full duplex
(p.
540).
Term: single-ended
Denotes a sensor or measurement terminal wherein the analog voltage signal
is carried on a single lead and measured with respect to ground (0 V).