COM9602 Short Burst Data Modem
6
The installation of the antenna and cable should begin by feeding the
antenna cable through the nut, then spacer, and finally antenna mount
(Figure 6-1). Next, loosen the 4 Phillips screws at the base of the antenna
and separate the two pieces. Feed the antenna cable through the bottom
half and secure the cable in place, reattach the bottom half of the antenna
and secure the 4 Phillips screws. Be sure to use the alignment notches on
the two halves before securing the antenna together.
Figure 6-1 Antenna, Mount, and Cable
Thread the antenna onto the ¾ inch supplied nut, being sure not to cross
the threads (Figure 6-2).
Figure 6-2 Antenna Attached to Mount
Содержание COM9602
Страница 2: ......
