Campbell COM320, Инструкция по эксплуатации

Страница: 35 / 48

B-1
Appendix B. Updating and Configuring
the COM320
The COM320 has an internal USB port for connecting the mode to a computer.
Connection to a computer is required to install the drivers, download an
operating system, change COM320 settings, and retrieve a vocabulary list.
The COM320’s case must be removed to access the USB port (see
Appendix B.1 ,
Removing the Cover to Access the USB Port
(p. B-1)
).
B.1 Removing the Cover to Access the USB Port
1) Use a Philips screwdriver to remove the five screws on the sides of the
COM320.
2) Lift off the case.
B.2 COM320 USB Communications Cable
The COM320 uses a USB Type-A Male to Type-B Male cable (pn 17648) for
updating firmware, vocabulary and configuration. This is a common USB
cable used with USB connected printers and scanners.
B.3 COM320 Driver Installation
If this is the first time a COM320 has been plugged into your computer, it will
be necessary to install the drivers to enable communication with the COM320:
1) Remove the cover of the COM320 to access the USB port (see Appendix
B.1 ,
Removing the Cover to Access the USB Port
(p. B-1)
).
2) Connect a USB cable between the COM320's USB port and one of your
computer's USB ports.
3) Power the modem by connecting the modem’s green 12V and G terminals
to a 12 Vdc power source or by connecting the modem to the CS I/O port
of a datalogger.
4) Open the Device Configuration Utility . Under Device Type, select Phone
Modem | COM320. Click the install the USB driver for the COM320
link and follow the prompts.
NOTE