Campbell COM200A, Инструкция по эксплуатации

Страница: 12 / 22

APPENDIX A. MODIFYING THE NON-VOLATILE MEMORY
A-2
TIP
R
IN
G
GND
SC12 Cable
Red
Black
10704 Adaptor
SC532
9 PIN PERIPHERAL TO RS232 INTERFACE
MADE IN USA
PERIPHERAL RS232
9227
To 12V
To GND
CAMPBELL
SCIENTIFIC
AUSTRALIA
PTY. LTD.
COM200A MODEM
S/N 0002
MADE IN U
SA
REN = 0.5
FIGURE A-2. COM200A to Computer Connection with 10704 Adaptor
Example Program 1
*Table 1 Program
01: 1 Execution Interval (seconds)
1: Initiate Telecommunications (P97)
1: 02 RF Modem/9600 Baud
2: 1 Disabled when User Flag 1
is High
3: 20 Seconds Call Time Limit
4: 0 Seconds Before Fast Retry
5: 0 Fast Retries
6: 0 Minutes before Slow Retry
7: 1 Failures Loc [ Failure ]
8: 0 Data Logger ID
2: Extended Parameters (P63)
1: 65 Option ;A
2: 84 Option ;T
3: 83 Option ;S
4: 48 Option ;0
5: 61 Option ;=
6: 51 Option ;3
7: 38 Option ;&
8: 87 Option ;W
3: Extended Parameters (P63)
1: 48 Option ;O
2: 68 Option ;D
3: 84 Option ;T
4: 13 Option
5: 00 Option
6: 00 Option
7: 00 Option
8: 00 Option
A.2 HAYES AT COMMAND SUMMARY
This manual does not attempt to be a primer on
the Hayes AT command set. The commands
are, therefore, only summarized below. For
most applications, these commands will not
need to be used. Except as noted, all
commands should begin with an “AT” and end
with a carriage return (hit the [Enter] key).
There are no “O” as in Oscar commands, only
“0” as in Zero commands. All commands must
be issued as CAPITAL letters.