NOTE: The Pan Tilt settings cannot be created or modified using
device configuration, therefore the Web Browser interface should
be used to configure these settings.
6.
Cables/Wiring
6.1
Power Cable Connections
The wiring for the Power Cable
connector and which wires need
to be connected for the intended camera application is as shown in
Table 9-1
Power Cable Connections
. The Orange Cable provides
power to the Controller Enclosure, this is the only cable that
requires wiring. The other two cables run from the controller to
the CCFC Field Camera (Black) and the Pan Tilt Base (Grey).
The Controller Enclosure does not require any setting
changes, therefore the enclosure should never be
opened.
TABLE 6-1 Power Cable Connection -ORANGE
Color
Function
Connection
When Not Used
Black
Power Ground System Ground
Red
Input Power
Power Source 12Vdc.
6.2
Power & I/O Cable Connections
6.2.1
CCFC Camera Power & I/O Cable Connection
The Black Cable (with 6 pin connector) runs from the Controller
Enclosure to the the CCFC Camera’s Power & I/O connector.
This cable provides power to the camera and allows the camera to
send commands to the Pan Tilt Controller.
6.2.2
Pan Tilt Base Power and I/O Cable Connection
The Grey Cable (with 15 pin connector) runs from the Controller
Enclosure to the Pan Tilt Base. The cable provides power to the
Pan Tilt Base and allows the Controller to send commands to the
Pan Tilt Base.
Note
