6. In Output Setup, type the scan rate, meaningful table names, and the Data Output Storage
Interval.
7. Select the measurement and its associated output option, typically Average for the solar
radiation measurement. Select Total for the PAR total measurement.
8. Click Finish and save the program. Send the program to the data logger if the data logger
is connected to the computer.
9. If the sensor is connected to the data logger, check the output of the sensor in the data
logger support software data display in
LoggerNet
,
RTDAQ
, or
PC400
to make sure it is
making reasonable measurements.
NOTE:
Short Cut
uses the execution interval to make total flux calculations (
(p. 10)). This
needs to be taken into account while editing the
Short Cut
program.
CS310 Quantum Sensor
4
