Campbell 110PV, Инструкция по эксплуатации

Страница: 18 / 38

110PV Surface Temperature Probe
10
FIGURE 7-2. 110PV mounted to a PV module using Kapton tape
7.3 Cable Strain Relief
The 110PV’s cable must be properly strain relieved after mounting the probe to
the measurement surface. To accomplish this, the probe comes with cable ties
and a cable tie mount. A yellow label on the 110PV’s cable indicates where
the cable should be tied down (see FIGURE 7-2 and FIGURE 7-3 ).
Placement of the cable inside a rugged conduit is advisable for
long cable runs, especially in locations subject to digging,
mowing, traffic, use of power tools, animals, or lightning strikes.
FIGURE 7-3. 110PV’s strain relief label
NOTE