Campbell 03002, Инструкция по эксплуатации

Страница: 19 / 39

R.M. Young Wind Sentry
10
7.2.2 Mounting the 03101 Anemometer to a Crossarm
1. Install the cup wheel to the anemometer shaft using the Allen wrench
provided with the sensor.
2. Mount the crossarm to the tripod or tower.
3. Secure the 3/4-inch IPS, 10-inch-long, threaded aluminum pipe to the
CM220 mount (FIGURE 7-1 ) or 3/4 x 1 inch Nu-Rail fitting (FIGURE 7-4 ).
4. Place the 03101 on the pipe.
5. Route the sensor cable to the instrument enclosure. If using a crossarm the
cable should be routed along the underside of the crossarm.
6. Secure the cable to the crossarm and tripod or tower using cable ties.
FIGURE 7-4. 03101 mounted to a crossarm via a 3/4 x 1 inch Nu-Rail
fitting
7.2.3 Mounting the 03002 or 03101 Atop a Tripod Mast
The 03002 and 03101 mount at the top of a CM106B, CM110, CM115, or
CM120 tripod with the CM216 (see FIGURE 7-5 ). The CM216 extends 10 cm
(4 in) above the mast of the tripod.
Cable Tie
Crossarm
Nu-Rail Fitting