![background image](http://html1.mh-extra.com/html/campbell-hausfeld/pw1826/pw1826_operating-instructions-and-parts-list-manual_3827121006.webp)
Operating Instructions and Parts Manual
www.chpower.com
Important Safety Information (Continued)
6666
serVIce
a. When servicing a tool, use only identical replacement
parts. Use only authorized parts.
servicing of a double-Insulated Appliance
In a double-insulated product,
two systems of insulation are
provided instead of grounding.
No grounding means are provided
for a double-insulated product,
nor should grounding means be
added to the product. Servicing a
double-insulated product requires
extreme care and knowledge of
the system, and should be done
only by qualified service personnel.
Replacement parts for a double-insulated product must be
identical to the original parts. A double-insulated product
is marked with the words “Double Insulation” or “Double
Insulated.” Product may also be marked with symbol shown
below.
sAVe these InstructIons — do not dIscArd
NOTE: The
DANGER
,
WARNING
,
CAUTION
, and
NOTICE
notifications and instructions in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
! IMPORTANT !
This pressure washer is equipped with a microswitch
sensitive to water flow. This Instant Start/Stop switch
(ISS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The ISS
then automatically turns the motor off to protect pump
from overheating.
oPerAtIon
1. Pull trigger on gun.
2. Turn the “ON/OFF” switch to “ON”.
3. Release trigger. The pressure washer motor will stop
running.
4. To spray again, pull trigger and motor and pump will
restart.
NOTE: Occasionally the motor may run for a short time
to bring fresh, cool water into the pump even if trigger
is released. This is part of normal operation and will not
damage the unit.
Always turn the “ON/OFF” switch
to “OFF” then trigger gun to release hose
pressure before unplugging power cord.
Risk of equipment damage. Always
make sure the “ON/OFF” switch on the
unit is “OFF” and unit is unplugged prior to storage.
Risk of Injection. Unit will start
spraying when trigger is squeezed if
ON/OFF switch is in “ON” position. Always point gun in safe
direction.
Double Insulated Symbol