Airless Paint
Sprayers
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
Assembly Instructions and Parts List
Airless Paint Sprayers
IN421000AV 3/02
BUILT TO LAST
Assembly Instructions
LIGHT DUTY CART MODELS
Tools required:
7/16” Wrench or
adjustable
11/16” Wrench or
adjustable
Hammer
1. Open packaging and check contents
against packing list on hardware pack.
2. Stand pump upright and hold steady.
Attach axle to cart legs by inserting
pre-assembled bolts into holes in cart
legs. Secure with one 1/4” - 20 nut on
each bolt. Use 7/16” wrench to tight-
en (See Figure 1).
3. Slide one 5/8” I.D. washer and wheel
on to each end of the axle. Using a
hammer, tap a pal nut onto each end
of the axle to retain the wheels (See
Figure 2).
4. Slide handle on to cart by depressing
the retaining snaps while pushing
handle in place. Be sure to check that
the retaining snaps lock into holes in
handle. Hose rack should be facing
the pump (See Figure 3).
5. Attach high pressure hose to pump
and spray gun using a 11/16” wrench
(See Figure 4). Do not attach suction
assembly at this time.
Assembly Instructions
HEAVY DUTY CART MODELS
1. Place washer from parts pack onto
axle.
2. Place wheel onto axle with side with
the longest hub going on first.
3. Place another washer on the axle.
4. Place cotter pin through hole in the
end of the axle.
5. Repeat for the other side (See
Figure 5).
6. Slide the two ends of the handle
over the two ends of the bottom
frame. The bend in the handle
should be away from the unit.
7. Stand behind the unit and reach
over the handle to grip the ends at
the bottom of the handle. Using
your thumb and forefinger, depress
the Valco Snaps and gently push
down on the handle until it starts
over the snaps. Then move your
hands to the top of the handle and
push it the rest of the way down
(See Figure 6).
8. When the handle is all the way
down the snaps will “click” into
place. If all four snaps do not pop
through, grasp the handle and twist
it right to left until the remaining
snap pops through.
CAM
PBE
LL
HAU
SFE
LD
Figure 1 - Attach Axle
Figure 2 - Attach Wheels
Figure 3 - Attach Handle
Figure 5 - Attach Wheels
Figure 4 - Attach Hose
Figure 6 - Attach Handle
Push
Lock
Push
Lock
For parts, product & service information
visit
www.chpower.com
© 2002 Campbell Hausfeld/Scott Fetzer