Campanola 776, Инструкция по эксплуатации

Страница: 17 / 69

4. Setting the Reference Position
The hands of the watch will not indicate the correct positions unless the reference position is set
properly. If the reference position has changed, reset it by following the procedure described
below.
* The reference position must also be reset after the battery has been replaced.
Perform the All-Reset procedure
If the crown is returned to the normal or 1st position without setting the
reference position after performing the All-Reset procedure, the reference
position failure alarm will be activated. At this time, the date hand will turn
counter-clockwise indicating that the reference position has not been set.
When this happens, pull out the crown to the 2nd position again, and perform
the procedure for setting the reference position.
84
C
AL.
6
77
＊
(A)
(B)
(C)
1)
Pull out the crown to the 2nd position.
2)
Press buttons (A), (B) and (C) simultaneously.
3)
When the buttons are released, the hands will move
in the order of the chronograph secondhand, date
hand, and year and month hands. A tone will sound
confirming that All-Reset has been performed when
this procedure is completed.