FT-133 Williamsburg Pineapple Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 315 lbs with an
approximate 1 sq. ft. footprint (actual dimensions 12.75" x 12.75").
Step 1 - Place the base (FT-132G) into position where the fountain will be installed, ensuring that
is it level.
FT-132G (135 lbs)
12.75"W x 25.75"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 2 - Center the large bowl (FT-132F) on the base (FT-132G).
Step 3 - Assemble the pump kit:
3a - Using a hose clamp, attach the 1/2" end non-kink end of the tubing assembly to the
pump outlet.
3b - Place the stopper around the pump cord approximately 8" from the pump.
Step 4 - Feed the pump cord through the hole in the large bowl (FT-132F) and through the base
(FT-132G).
Step 5 - FIRMLY press the stopper into the hole evenly.
5a - NOTE: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 6 - Place the pump cover (FT-133B) over the pump and in the center of the large bowl
(FT-132F).
FT-132F (111 lbs)
30"W x 8.5"H
FT-133B (8 lbs)
9"W x 5.75"H
