FT-304 Westover Fountain
Two people are recommended for the installation of this fountain!
Revised June 26, 2017
Assemble your fountain on a level surface capable of holding a minimum of 289 pounds with an approximate 1 square foot footprint.
FT-77E (114 lbs)
11.5”L x 11.5”W x 21.25”H
FT-77D (96 lbs)
28.5”W x 10.75”H
FT-304C (5 lbs)
7.25”W x 7”H
FT-304B (15 lbs)
15.5”W x 4.25”H
FT-77A/78A (5 lbs)
5”W x 8.5”H
FT-304CC (2 lbs)
4.5”L x 1”W x 4.5”H
1.
Place the base (FT-77E) into position where the fountain will be installed,
ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2” non-kink tubing to the pump
outlet.
b.
Place the stopper around the pump cord about 6” from the pump.
3.
Center the large bowl (FT-77D) over the base (FT-77E).
4.
Feed the pump cord through the hole in the large bowl (FT-77D) and the
channel in the base (FT-77E).
5.
FIRMLY
press the stopper into the hole evenly.
a.
Note:
Using the handle of a screwdriver or hammer works best.
6.
Place the pump house (FT-304C) over the pump and in the center of the large
bowl (FT-77D).
7.
Feed the non-kink tubing through the top of the pump house (FT-304C).
8.
Center the small bowl (FT-304B) over the pump house (FT-304C).
9.
Use a hose clamp to secure the loose end of the non-kink tubing to the pipe
protruding from the bottom of the small bowl (FT-304B).
10.
Center the finial (FT-77A/78A) over the small bowl (FT-304B).
11.
Fit the pipe protruding from the top of the small bowl (FT-304B) into the
hole in the bottom of the finial (FT-77A/78A).
12.
Fit the pump house door (FT-304CC) into the pump house (FT-304C).
13.
Fill the fountain with water.
