background image

FT-377 St Helena Fountain 

Assembly Instructions

Assemble your fountain on a level surface capable of holding a minimum of 25 lbs with 

an approximate 0.5 sq. ft. footprint (actual dimensions 7" Diam.).

Step 1 -

 Assemble the pump kit:

 

1a – Do not connect the pump to the transformer until assembly is complete.

 

1b -  

Using a hose clamp and screwdriver, attach the 1/2" end of the non-kink tubing to 

the pump adapter.

Step 2 - 

Place the pump flat on its side in the bottom of the bowl (FT-377B).

Step 3 -  

Feed the pump cord through the channel cut in the top lip of the fountain bowl, so the 

cord hangs down the back of the fountain.

 

Step 4 -

  Insert the CPVC end of the tubing assembly into coupling on the bottom of the water 

feature (FT-377A).

Step 5 -

  Place the water feature (FT-377A) on top of the basin (FT-377B) making sure that it  

is level.

 

5a -

  Note: Rotating the disc while lowering it onto the basin will coil the non-kink tubing 

inside the basin and help the disc to sit flat.

Step 6 -

 Connect the pump cord to the transformer.

Step 7 -

 Fill the fountain with water.

FT- 377B (12 lbs) 

12.25"W x 6"H

Fountain Set-Up:

 

Assembly & Installation - 

A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is  

installed properly, please read our instructions and tips before you begin.

 

Step 1 -   Seek Professional Help:

 Check if professional installation is recommended for your fountain.

 

Step 2 -   Check Foundation: 

Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed  

gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.

 

Step 3 -   Create a Drip Loop:

 To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing  

the pump power cord to fall below the wall outlet.

 

Step 4 -   Use a GFCI Outlet:

 Use only a GFCI outlet when running a fountain.

FT- 377A (5 lbs) 

10.5"W x 2"H

Отзывы: