FT-255 Paradiso Fountain
Revised August 7, 2018
Assemble your fountain on a level surface capable of holding a minimum of 106
pounds with an approximate 1 square foot footprint.
FT-255B (59 lbs)
22.25”W x 15.5” H
FT-255A (6 lbs)
7.75”W x 4.5” H
FT-255C (3 lbs)
5.5”W x 2.5” H
1.
Position the basin (FT-255B) where the fountain
is to be installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2" non-
kink tubing to the pump outlet.
b.
Place the stopper around the pump cord
approximately 6 inches from the pump.
3.
Feed the pump cord through the hole in the basin
(FT-255B) and out of the channel.
4.
FIRMLY press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or
hammer works best to press the stopper in
place.
5.
Place the pump cover (FT-255A) over the pump.
6.
Insert the CPVC end of the tubing into the
bottom of the water feature (FT-255C).
7.
Place the water feature into the basin ensuring
that it is level.
a.
Turn the feature and coil the tubing as you
lower it into position.
8.
Fill the fountain with water.
