FT-341 Oslo Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 176 lbs with an
approximate 1/2 sq. ft. footprint (actual dimensions 8" diam.).
Step 1 - Position the basin (FT-341C) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the non-kink end of the tubing assembly to the pump
outlet.
2b - Place the stopper around the pump cord approximately 6" from the pump.
Step 3 - Feed the pump cord through the hole and channel in the basin (FT-341C).
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper in
place.
FT-341C (146 lbs)
25"L x 25"W x 32"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 6 - Holding the water feature disc (FT-341A) over the basin, insert the CPVC connected to the
non-kink tubing into the PVC coupling protruding from the bottom of the disc.
Step 7 - Carefully place the water feature onto the pump house ring (FT-341B) ensuring that it is
centered and level.
7a - Rotate water feature as you lower it into position to coil the non-kink tubing.
Step 8 - Fill the fountain with water.
FT-341A (3 lbs)
7"W x 3.5"H
Step 5 - Place the pump cover (FT-341B) over the pump.
FT-341B (2 lbs)
7.25"W x 1.5"H
