FT-264 M-Series Medallion Fountain
Assembly Instructions
Step 6 - Fill the basin enough to cover the pump completely with water to check for leaking.
6a - If leaking occurs…
- Remove the stopper and repeat step 5 again.
- Use some of the excess putty to seal the cord around the top of the stopper.
See image “D”.
- Let the fountain dry completely, then use 100% clear silicone to seal around the
pump cord and perimeter of the stopper. Silicone must set for 24 hours before
adding water.
D
Step 7 - Holding the water feature (FT-264A) over the basin (FT-264B), insert the CPVC end of the
tubing into the coupling protruding from the bottom.
Step 8 - Center the water feature (FT-264A) into basin (FT-264B).
Step 9 - Connect the pump cord to the transformer.
FT-264A (8 lbs)
11.25"W x 2"H
