FT-225 Longvue Fountain
Two people are recommended for the installation of this fountain!
Revised June 2, 2017
Assemble your fountain on a level surface capable of holding a minimum of 630 pounds with an approximate 1.75 square foot
footprint.
FT-225F (224 lbs)
16.25”L x 16.25”W x 24.5”H
FT-239E (210 lbs)
36.5”W x 10”H
FT-225C (39 lbs)
10”W x 13”H
FT-225B (56 lbs)
21.5”W x 6.75”H
FT-225A (11 lbs)
5.5”W x 11”H
FT-225D (2 lbs)
5.5”L x 1.5”W x 3.5”H
1.
Place the base (FT-225F) into position where the fountain will be installed,
ensuring that it is level.
2.
Assemble the pump kit
a.
Attach the non-kink tubing to the pump outlet.
b.
Place the stopper around the pump cord about 6” from the pump.
3.
Center the large bowl (FT-239E) over the base (FT-225F).
4.
Feed the pump cord through the hole in the large bowl (FT-239E) and the
channel in the base (FT-225F).
5.
FIRMLY
press the stopper into the hole evenly.
a.
Note:
Using the handle of a screwdriver or hammer works best.
6.
Place the pump house (FT-225C) over the pump and in the center of the large
bowl (FT-239E).
7.
Feed the non-kink tubing through the top of the pump house (FT-225C).
8.
Center the small bowl (FT-225B) over the pump house (FT-225C).
9.
Use a hose clamp to secure the loose end of the non-kink tubing to the pipe
protruding from the bottom of the small bowl (FT-225B).
10.
Center the finial (FT-225A) over the small bowl (FT-225B).
11.
Fit the pipe protruding from the top of the small bowl (FT-225B) into the hole in
the bottom of the finial (FT-225A).
12.
Fit the pump house door (FT-225D) into the pump house (FT-225C).
13.
Fill the fountain with water.
