GFRCFT-1109 Tall Cylinder Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 184 lbs with an approximate 2 sq. ft. footprint
(actual dimensions 19.5" Diam.).
Step 1 - Unpack the provided pump kit.
Step 2 - Place the pump inside the base of the fountain.
Step 3 - Feed the pump cord through the standpipe in the center of the basin, leaving enough cord length inside of the basin
to work with the pump sitting flat in the bottom of the bowl.
3a - When the pump cord exits the base of the fountain, make sure it lines up with the channel that is cut into the
bottom of the basin.
Step 4 - Insert the #5 Drain stopper into the hole in the bottom of the basin.
Step 5 - Insert the pump into the tubing that is already attached to the cylindrical water feature.
Step 6 - Place the cylindrical water feature on top of the basin.
6a - Center the cylindrical water feature on top of the basin.
Step 7 - Fill the fountain with water.
Note: When running the fountain there may be some areas where the water does not flow properly. This can be fixed by
running a hand over the top surface and down the sides.
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.