FT-380 Mondrian Fountain, Tall
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 640 lbs with
an approximate 1.25 sq. ft. footprint (actual dimensions 21"L x 13.5"W).
Step 1 - Stand up the water feature (FT-380B) placing it into position where the fountain will be
installed.
1a - NOTE - If placing against a wall leave enough space to pass your arm behind it. The
fountain can be moved back after pump installation is completed and the cord has
been run behind the fountain.
Step 2 – Line the base (FT-380E) up with the sides of the water feature. There should be about 2-3
inches of space between the two pieces.
Step 3 - Center the basin (FT-380D) in front of the water feature (FT-380B) and on top of the base
(FT-380E), but do not fit into water feature yet.
3a – There is a slight bevel/slant to one side of the basin. This is the side that will fit into
the water feature (FT-380B).
Step 4 - Assemble the pump kit:
4a - Using a hose clamp, attach the 1/2" non-kink end of Tubing Assembly #1 to the pump
outlet.
4b - Place the stopper around the pump cord approximately 6" from the pump.
Step 5 - Feed the pump cord through the large hole in the back of the basin (FT-380D).
Step 6 - FIRMLY press the stopper into the hole evenly.
Step 7 – Use a hose clamp to secure the loose end of Tubing Assembly #1 to the CPVC pipe pro-
truding out on the inside the basin (FT-380D).
Step 8 – Use hose clamps to secure one end of Tubing Assembly #2 to the CPVC pipe in the back
of the basin (FT-380D) and the other end to the pipe in the top of the cut out in the back
of the feature (FT-380B).
Step 9 – Lift the basin (FT-380D) into position in the water feature (FT-380B).
9a - NOTE – The basin will only go up to a 1/4" inside water feature hole.
Step 10 - Check sides of basin so that gaps on both sides against water feature are even.
Step 11 – Insert the drain stopper (DRAIN-7) into the drainage hole.
FT-380B (269 lbs)
23"L x 7.5"W x 52"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
FT-380E (21 lbs)
21"L x 6"W x 4"H
FT-380D (232 lbs)
27"L x 16"W x 15"H
