FT-344 Concourse Sphere Fountain
Assembly Instructions
Professional installation is recommended for this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 3510 lbs with an
approximate 8 sq. ft. footprint (actual dimensions 84.5" x 84.5").
Step 1 - Place the fiberglass basin where the fountain is to be installed.
1a - Be sure to check that each part is level and centered during the assembly of
the fountain.
Step 2 - Assemble the pump kit:
2a - Connect the non-kink tubing to the pump.
2b - Place the stopper around the pump cord approximately 3 ft. from the pump.
Step 3 - Feed the pump cord through the hole in the basin (FGB-2130) and the channel.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - NOTE: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 5 - Loosely wrap cord up in the center of the basin.
Step 6 - Place the pedestal (FT-344A) over the pump, ensuring that it is centered and level.
Step 7 - Position the water feature (6091-9701) over the pedestal (FT-344A).
Step 8 - Connect the loose end of the non-kink tubing to the pipe protruding from the bottom of
the water feature (6091-9701).
Step 9 - Fit the water feature (6091-9701) into the inset space on the top of the pump house
(FT-344A).
Step 10 - Insert the pump cover door (FT-343C) into the pedestal (FT-344A).
FGB-2130 (175 lbs)
84"L x 84"W x 11.25"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
FT-344A (126 lbs)
14"L x 14"W x 17"H
6091-9701 (36 lbs)
28"L x 28"W x 23.5"H
FT-344B (7 lbs)
7.5"L x 2"W x 6.75"H
