FT-302 Echo Park Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 383 lbs with an
approximate 1 sq. ft. footprint (actual dimensions 12" Diam.).
Step 1 - Position the basin (FT-302C) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, connect the tubing to the pump outlet.
2b - Place the stopper around the pump cord approximately 6" from the pump.
Step 3 - Feed the pump cord through the hole and channel in the basin (FT-302C).
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
FT-302C (269 lbs)
28"W x 17.5"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Center the large disc (FT-302B) inside the basin, ensuring that it is centered and level.
Step 6 - Fill the fountain with water.
Step 7 - Holding the water feature disc (FT-302A) over the large disc (FT-302B), insert the PVC
connected to the non-kink tubing into the PVC coupling protruding from the bottom.
Step 8 - Carefully place water feature disc (FT-302A) into the large disc (FT-302B) ensuring that it
is centered.
FT-302B (43 lbs)
24.25"W x 1.25"H
FT-302A (4 lbs)
7.5"W x 3"H
