FT-30 Palazzo Urn Fountain
Three people are recommended for the installation of this fountain!
Revised July 11, 2018
Assemble your fountain on a level surface capable of holding a minimum of 1135 pounds with an approximate 14 square foot
footprint.
FT-29C/30D (579 lbs)
45”L x 45”W x 11”H
FT-29B/30C (52 lbs)
12”L x 12”W x 8”H
FT-30B (115 lbs)
12”L x 12”W x 16.5”H
FT-30A (134 lbs)
18”L x 18”W x 21”H
FT-29BB/30CC (4 lbs)
5”L x 1”W x 5”H
1.
Place the basin (FT-29C/30D) into position where the fountain will be installed, ensuring that it
is level.
2.
Assemble the pump kit
a.
Connect the preassembled tubing
(diagram right) to the pump by
sliding the 12" length of non-kink
tubing over the pump outlet.
b.
Place hose clamps on each of the
ends of the 6” non-kink tubing.
c.
Place the stopper around the pump
cord approximately 8 inches from
the pump.
3.
Feed the pump cord through the hole in the
basin (FT-29C/30D) and the channel.
4.
FIRMLY press the stopper into the hole
evenly.
a.
Note: Using the handle of a
screwdriver or hammer works best
to press the stopper in place.
5.
Place the pump cover (FT-29B/30C) over the pump. Ensure it is placed properly and leveled.
BOTTOM OF COLUMN (FT-30B)
6.
Secure the 2 open ended 6” pieces of non-kink tubing to the 2 pipes protruding from the bottom
of the column (FT-30B).
7.
Center the column (FT-30B) on top of the pump cover (FT-29B/30C).
INSIDE OF COLUMN (FT-30B)
8.
Use a hose clamp to attach the 30” length of non-kink tubing to one of the two pipes protruding
on the inside of the column (FT-30B).
BOTTOM OF URN (FT-30A)
9.
Use another hose clamp to secure the other end of the 30” non-kink tubing to the pipe protruding
from the
CENTER
of the urn (FT-30A).
10.
Center the urn (FT-30A) over the column (FT-30B).
INSIDE OF URN (FT-30A)
11.
Place a copper sleeve over each of the copper pipes inside the urn (FT-30A).
12.
Place the 8” copper pipe over the pipe protruding up from the
CENTER
of the urn (FT-30A).
a.
If a spray head is desired, place the third copper sleeve over the 8” copper pipe that is
centered inside the urn and place the spray head onto the copper sleeve.
13.
Place the 6 ½” copper pipe over the remaining pipe protruding off-center inside the urn.
14.
Place the pump cover door (FT-29BB/30CC) in the pump access opening of the pump cover
(FT-29D/30C).
15.
Fill the basin with water.
