FT-251 Hydrangea Leaves Two Tier Fountain
Revised April 6, 2017
Assemble your fountain on a level surface capable of holding a minimum of 280 pounds with an approximate 8 square inch footprint.
FT-249F (60 lbs)
11”W x 10”H
FT-249E (108 lbs)
27.75”W x 8.25”H
FT-249C (9 lbs)
8.5”W x 5.5”H
FT-249B (43 lbs)
20.25”W x 6.5”H
FT-248A (16 lbs)
16.75”W x 1”H
FT-249D (2 lbs)
5”L x 1.5”W x 4”H
1.
Place the base (FT-249F) into position where the fountain will be installed.
2.
Assemble the pump kit
a.
Using a hose clamp, fasten the 1/2" non-kink black tubing to the
pump
b.
Place the stopper around the pump cord approximately 4-6” from the
pump.
3.
Feed the pump cord through the large bowl (FT-249E) and base (FT-249F)
until the stopper reaches the hole in the bottom of the bowl.
a.
Be sure the cord is fed through the channel at the bottom of the base.
4.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best.
5.
Place the pump house (FT-249C) over the pump and in the center of the large
bowl (FT-249E).
6.
Holding the small bowl (FT-249B) over the pump house (FT-249C), insert
the CPVC connected to the tubing and pump into the CPVC coupling on the
bottom of the bowl.
7.
Center and level the small bowl (FT-249B).
8.
Press the CPVC coupling and pipe that were already assembled firmly over
the CPVC pipe protruding inside the small bowl (FT-249B).
9.
Center and press the water feature disc (FT-248A) over the CPVC pipe in the
small bowl (FT-249B).
a.
Note: Look through the copper spout in the top of the disc to line up
the pipes in the disc and small bowl.
10.
Place the pump house door (FT-249D) into the pump house (FT-249C).
11.
Fill the basin with water.
