FT-202 Zen Plinth Fountain
Revised April 6, 2017
Assemble your fountain on a level surface capable of holding a minimum of 138 pounds with
an approximate 1.75 square foot footprint.
FT-134C (66 lbs)
25”L x 10”W x 8.25”H
FT-202A (42 lbs)
8.5”L x 13.25”W x 15”H
FT-134B (4 lbs)
1.25”L x 6.25”W x 6.5”H
1.
Position the basin (FT-134C) where the fountain is to be
installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2" non-kink tubing to
the pump outlet.
b.
Place the stopper around the pump cord about 6” from
the pump.
3.
Feed the pump cord through the hole and out of the channel in
the bottom of the basin (FT-134C).
4.
FIRMLY
press the stopper into the hole evenly.
a.
Note:
Using the handle of a screwdriver or hammer
works best.
5.
Place the water feature (FT-202A) on the basin (FT-136C).
6.
Use a hose clamp to attach the other end of the non-kink
tubing connected to the pump to the pipe at the bottom of the
water feature (FT-202A).
7.
Place the pump cover (FT-134B) in front of the pump
assembly and push back until properly seated.
8.
Fill the fountain with water.
