FT-247 Equinox Birdbath Fountain
Revised June 21, 2018
Assemble your fountain on a level surface capable of holding a minimum of 70 pounds with an
approximate 8 square inch footprint.
FT-246B (116 lbs)
20.5”W x 30.25”H
FT-247A (16 lbs)
16.75”W x 1”H
1.
Position the base (FT-246B) where the fountain is
to be installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, connect the 1/2" non-
kink tubing to the pump.
b.
Place the stopper around the pump cord
approximately 3-5” from the pump.
3.
Feed the pump cord through the base (FT-246B)
until the stopper reaches the hole.
a.
Be sure the cord is fed through the channel
at the bottom of the base.
4.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or
hammer works best to press the stopper in
place.
5.
Insert the CPVC pipe connected to the tubing and
pump into the CPVC coupling on the bottom of
the water feature disc (FT-247A).
6.
Center and level the disc (FT-247A).
7.
Fill the fountain with water.
