FT-336 Concept Birdbath Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 225 lbs with an
approximate 0.5 sq. ft. footprint (actual dimensions 8.5" x 8.5").
Step 1 - Position the basin (FT-336B) where the fountain is to be installed, ensuring that it is level.
Step 2 - Place the O-Ring around the Light/Spout.
2a - The O-Ring will secure the Light/Spout in place and allow for water to fl ow correctly
in the fountain. (see image below).
Step 3 - Attach the non-kink tubing to the Light/Spout.
Step 4 - Feed the Light/Spout cord and non-kink tubing through the hole in the top of the water
feature disc (FT-336A).
Step 5 - Carefully press the Light/Spout with O-Ring into the hole at the top of the hole in the disc.
5a - Note: Use a fl athead screwdriver or similar tool to press the O-Ring deeper into the
hole around the Light/Spout.
Step 6 - Attach the Pump to the non-kink tubng with a hose clamp.
Step 7 - Feed both cords through the PVC pipe in the basin (FT-336B) and out of the channel
underneath.
7a - Note: Binding the 2 cords together with a zip tie, twist tie, or string makes this step
easier.
7b - Note: Be sure to place one plug below the other. If you try forcing both plugs through
at the same time, they will not fi t. (see image below).
FT-336B (196 lbs)
24.75"W x 32.75"H
Fountain Set-Up:
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Light/Spout
FT-336A (3 lbs)
5.75"W x 2"H
Pump
