FT-153 Beaufort Fountain
Professional installation is recommended for this fountain! Assemble your fountain on a level surface using crushed stone, gravel, or
cement pad as the base.
Revised April 23, 2018
FT-114D (116 lbs)
32”W x 9.5”H
FT-115A (35 lbs)
8”W x 17”H
FT-114F (3 lbs)
5.25”L x 2”W x 4”H
FT-239L (8 lbs)
8.25”L x 1.75”W x 6.5”H
FT-124K (282 lbs each)
38”L x 9”W x 15”H
17.
Place a hose clamp over the top end of the tubing and connect that end of the
tubing to the bottom of the middle bowl (FT-114D). Tighten the hose clamp to
ensure a good seal.
18.
Place the middle bowl down onto the middle pedestal.
19.
Place the finial (FT-114A) in the small bowl by lowering the hole over the
copper pipe protruding from the bowl.
20.
Cover the middle pedestal pump access with the pump cover door (FT-114F).
21.
Cover the pump access in the bottom base with the pump cover door (FT-124J).
22.
Place 1 piece of coping (FT-124K) directly against the fiberglass basin (FGB-
2020).
23.
Place 1 wood spacer against the bottom outer edge of the first piece of coping.
a.
Leave about 1 inch of the spacer sticking out for easy removal.
24.
Position the second coping against the wood spacer and basin.
25.
Repeat steps 23 and 24 until only 1 piece of coping is not in place. There should
be a gap between copings where the inside corners meet.
26.
Insert 1 plastic wedge about 3 inches from each edge of the 7 copings already
installed. (This reduces the gap in the inner circle of the coping.)
27.
Carefully push the final piece of coping into place and place the 2 wedges under
a.
Adjust the other copings as needed to form a circle.
28.
Remove the wood spacers.
29.
Fill the basin with water.
