FT-290 Avignon Fountain
Three people are recommended for the installation of this fountain!
Revised October 21, 2017
Assemble your fountain on a level surface capable of holding a minimum of 900 pounds with an approximate 8 square foot footprint.
FT-290F (602 lbs)
52”W x 12.25”H
FT-290D (55 lbs)
13.25”W x 10.5”H
FT-290B (180 lbs)
11”W x 29.25”H
FT-290C (4 lbs)
7”W x 1.25”H
FT-290A (83 lbs)
83”W x 10”H
FT-290E (4 lbs)
6.75”L x 1.5”W x 6.5”H
1.
Place the basin (FT-290F) into position where the fountain will be installed,
ensuring that it is level.
2.
Assemble the pump kit
a.
Connect the preassembled tubing to the pump by sliding the 3/4" clear
tubing over the pump outlet.
b.
NOTE: All pumps come with 1 adapter already inserted into the pump
and 2 adapters secured to the power cord.
i.
This fountain uses the largest adapter provided.
c.
Place the stopper around the pump cord approximately 8 inches from the
pump.
3.
Feed the pump cord through the hole in the basin (FT-290F) and the channel.
4.
FIRMLY press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best to press the
stopper in place.
5.
Place the pump cover (FT-290D) over the pump, ensuring that it is centered and
level.
6.
Insert the CPVC pipe connected to the tubing into the pipe protruding out of the
bottom of the column (FT-290B).
7.
Place silicone around the straight end of the 3 spouts and twist each one carefully
into the holes on water feature (FT-290B).
a.
Note: Be sure the spout is facing down toward the basin after they are
inserted.
b.
Note: CPVC Pipe has already been inserted into the spillers to promote an
even water flow. If the pipe comes out, simply reinsert them back into the
spiller.
8.
Place the disc (FT-290C) inside of the top of the column (FT-290B).
9.
Center the cap (FT-290A) on top of the column (FT-290B).
10.
Insert the pump cover door (FT-290E) into the pump cover (FT-290D).
11.
Let Silicone dry for 24 hours before filling the basin with water.
