FT-120 Andalusia Fountain
Professional installation is recommended for this fountain!
Revised October 15, 2019
Assemble your fountain on a level surface capable of holding a minimum of 2200 pounds with approximately a 13.5
square foot footprint.
FT-120C (1080 lbs)
56.25”L x 30”W x 17.5”H
FT-120A (532 lbs)
55”L x 16”W x 38”H
(2) FT-120CAP (>1 lb)
1”L x 1”W x 1”H
FT-120B (37 lbs)
13”L x 7.5”W x 15.25”H
1.
Place the base (FT-120C) into position where the fountain will be installed, ensuring
that it is level.
2.
Using a caulking gun, run a bead of silicone along the top of the basin (FT-120C)
where the water feature (FT-120A) will be placed. Take care not to use too much
silicone to minimize oozing of silicone from between the pieces.
3.
Place the water feature (FT-120A) on top of the basin (FT-120C) making sure that
the PVC pipe holes are lined up between the top of the basin and the bottom of the
water feature.
4.
BE CAREFUL NOT TO PINCH FINGERS WHEN LOWERING!
a.
Hand holds have been molded into the water feature for easier
assembly.
5.
Clean off any excess silicone with your finger or a dry rag as quickly as possible.
6.
Using a hammer, gently tap the 2” length of CPVC pipe into the PVC coupling in
the bottom of the water feature (FT-120A).
a.
Note: To prevent breakage, do not do this step early.
7.
Place the #5 drain stopper into the hole at the bottom of the bowl on the water
feature (FT-120A).
8.
Drop the support pipes into the holes at the top of the water feature (FT-120A).
a.
Check that the pipes have dropped all the way through the water feature
(FT-120A) AND basin (FT-120C) before going forward.
9.
Insert the stone caps (FT-120CAP) into the holes over the pipes.
a.
Note: The caps are removable.
10.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2" black tubing to the pump outlet.
11.
Place the pump and LED light in the fountain and feed the cords through the hole
between the basin (FT-120C) and water feature (FT-120A).
a.
Attach the LED light to the transformer outside of the fountain.
12.
Fit the other piece of 5/8” clear tubing over the CPVC installed into the water
feature (FT-120A) in step 6.
13.
Place the pump cover (FT-120B) over the pump along the back of the basin.
14.
Place the #7 drain stopper into the hole at the bottom front of the basin.
15.
Place LED light in the front of the basin aiming the light at the waterfall.
16.
Let the fountain sit 24 hours before filling it with water.
