FT-191 Acanthus Two Tier Fountain
Two people are recommended for the installation of this fountain!
Revised January 10, 2018
Assemble your fountain on a level surface capable of holding a minimum of 456 pounds with an approximate 1.5 square foot
footprint.
FT-191F (207 lbs)
15.25”L x 15.25”W x 27”H
FT-191E (134 lbs)
32.5”W x 9”H
FT-191C (30 lbs)
9.5”W x 13.5”H
FT-191B (24 lbs)
16”W x 4.75”H
FT-191A (8 lbs)
5.25”W x 9.5”H
FT-191D (2 lbs)
5.5”L x 1.5”W x 4”H
1.
Place the base (FT-191F) into position where the fountain will be installed,
ensuring that it is level.
2.
Assemble the pump kit
a.
Attach the non-kink tubing to the pump outlet.
b.
Place the stopper around the pump cord about 6” from the pump.
3.
Center the large bowl (FT-191E) over the base (FT-191F).
4.
Feed the pump cord through the hole in the large bowl (FT-191E) and the
channel in the base (FT-191F).
5.
FIRMLY
press the stopper into the hole evenly.
a.
Note:
Using the handle of a screwdriver or hammer works best.
6.
Place the pump house (FT-191C) over the pump and in the center of the large
bowl (FT-191E).
7.
Feed the non-kink tubing through the top of the pump house (FT-191C).
8.
Center the small bowl (FT-191B) over the pump house (FT-191C).
9.
Use a hose clamp to secure the loose end of the non-kink tubing to the pipe
protruding from the bottom of the small bowl (FT-191B).
10.
Center the finial (FT-191A) over the small bowl (FT-191B).
11.
Fit the pipe protruding from the top of the small bowl (FT-191B) into the hole in
the bottom of the finial (FT-191A).
12.
Fit the pump house door (FT-191D) into the pump house (FT-191C).
13.
Fill the fountain with water.
