144533-XX01 Boden Fountain, Short
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 179 lbs with an approximate 0.75 sq. ft.
footprint (actual dimensions 11.5" Diam.).
Step 1 - Assemble the pump kit:
1a - Using a hose clamp, secure the 1/2" end of the tubing assembly to the pump.
Step 2 - Remove the cap covering the standpipe.
Step 3 - Feed the pump cord through the standpipe until the cord exits the bottom of the basin and can be plugged in.
3a - Note: Leave enough cord length inside of the basin to work with the pump sitting flat on its side in the bottom
of the bowl.
Step 4 - Replace the cap to cover the standpipe and cord.
Step 5 - Slide the 5/8" end of the tubing assembly onto the copper pipe extending down from the bottom of the water feature.
Step 6 - Place the water feature on top of the basin making sure that the water feature is level.
6a - Note: Wedges may be used if necessary to level the water feature.
6b - Note: Do not fill water over the top of the standpipe.
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
