Before mounting we recommend to test the antenna at the selected mounting place!
In some cases it may happen that the antenna does not work properly.
After checking pls mount the antenna as follows:
Preparation
:
1. Assure that the roof of your vehicle is able to carry the antenna. If you are not sure pls
fix a metal plate (Alu, appr. 2mm thickness) onto the roof. Pls also ask the vehicle's
manufacturer.
2. Pleas check completeness of parts.
3. Put the antenna on the selected mounting place on the car roof and adjust if
necessary. The mounting place must be even and no other roof constructions may
cover the reception area of the antenna.
Mark the outline of antenna feet with a suitable pen.
In case of problems (e.g. the roof is not even but has a curved form instead) pls call our
hotline to arrange further steps.
4. Replace the antenna.
Clean the mounting place and the antenna feet with the supplied special cleaning fluid
"Reiniger1" and the supplied fleece (pls wear the supplied Latex gloves!).
Grind the marked fixing areas and antenna feet with sandpaper (not too much, the
surface must be rough a little bit only), clean the surface and antenna feet with cleaning
fluid 1 again and wait another 10 minutes.
Attention! Now do not touch the cleaned surface any more!
5. Apply (with the help of the wool wiper - pls wear the supplied Latex gloves!) the
Primer 2 evenly and thin onto the cleaned surface and feet. Then pls wait another 10
minutes.
Attention! Do not touch the cleaned surfaces any more!
Close the Primer 2 bottle at once after use.
Note
:
If the surface of the mounting place is made from unknown material, we recommend a
"test sticking". If necessary we can arrange a material analysis at your cost.
Sticking the antenna to your vehicle's roof:
1. Cut the tip of the supplied cartouche special glue "Spezialkleber 3" (pls wear the
supplied Latex gloves!).
2. Apply evenly the glue onto the antenna feet (thickness of glue layer appr. 3 to 4mm
antennas base
bottom of antenna
Screw hole
