Camoplast Tatou UTV T4S, Руководство пользователя, Страница: 76 / 88

73
TROUBLESHOOTING
TROUBLESHOOTING
Problem Potential cause Correction
Presence of debris in the system.
Remove any debris which could
prevent the proper operation of the
system
Severe and localized wear on a
wheel (flat spot)
Replace the part
Frozen sprocket or wheel
Remove the ice/snow build-up.
Storing the vehicle at temperatures
higher than 0 °C might be required
Beginning of derailing
Check tensioner alignment. Make
sure that the track is well guided by
the wheels and the track guide.
Realign the system if it's needed.
The presence of dirt on the UTV
during the installation of the system
could cause bad seating of hub
mating surfaces of the UTV and the
track system.
Remove the system and clean the
contact surfaces between the hubs.
Damaged hub or wheel bearing Replace the damaged bearing
Hub of the UTV or of the track
system
deformed following an
impact or abusive use
Replace the deformed part
Incorrect ajustement of the track
system's angle of attack.
Adjust the angle of attack according
to the manufacturer's specifications.
(Refer to the "Adjustments" section
of the manual)
Track tension too high
Adjust of the track tension.
(Refer to the "Adjustments" section
of the manual)
Wrong alignment of the system
Correct the system alignment
(Refer to the "Adjustments" section
of the manual)
Wheel blocked
Try to free the wheel and replace if
necessary
Constant turn
Vary your turning radius and seek
areas which can lubricate the system
Uninterrupted use of the system in
paths with ruts
Vary your line (out of the ruts) and
seek zones which can lubricate the
system
Clean the sprocket of mud, snows or
any contaminants build up.
Remove ice/snow build up on wheels
Clear frame and wheels of
compacted snow.
Infiltration of snow in the air intake
system of the UTV. Remove snow and immediately
contact the dealer to fix the situation.
Severe wear of one or several
components Check tensioner alignment. Verify
track guide and wheel wear.
Track tension too low
Adjust the track tension.
(Refer to the "Adjustments" section
of the manual)
Incorrect alignment of the track
system and/or incorrect angle of
attack.
Adjust the angle of attack and
alignment according to the
manufacturer's specifications.
(Refer to the "Adjustments" section
of the manual)
Insufficient snow flotation
Incorrect adjustment of the anti-
rotation mechanism.
Adjust the angle of attack according
to the manufacturer's specifications.
(Refer to the "Adjustments" section
of the manual)
TROUBLE SHOOTING
Loss of power
Partial or total derailing
Track tension too high
Overheating of system
guiding components (burned
rubber odor)
Unstable behavior
Abnormal vibration