NUFLO™
Scanner
®
2000 Expansion Board
Quick
Start
Align hole in
expansion board
with standoff.
Align pins on back
of expansion board
with black headers.
Part No. 9A-30165026, Rev. 03
The Scanner 2000 Expansion Board expands the
Scanner 2000’s input/output to include:
an additional turbine input
a pulse input (3-30 VDC or contact closure)
two analog inputs (1-5 V, 0-5 V, or 4-20 mA)
an analog output (4-20 mA)
•
•
•
•
Installation
Before installing the
expansion board,
remove all power from
the Scanner 2000
(battery and external
power). The expansion
board attaches to two
headers positioned
between the two large
terminal blocks on the
main board. Remove
wiring from the main
board if necessary to
guide the expansion
board into position.
Remove the standoff
from packaging and
press it into the hole
near the center of the
main board until it
snaps into place.
Guide the expansion
board over the stand-
off and align the pins
on the under side
with the headers on
the main board.
1.
2.
When the board is
positioned correctly,
text on both boards
should face the same
direction.
Gently press the
expansion board and
the main board
together until the
expansion board
snaps into place over
the standoff.
3.
Restore wiring con-
nections to the main
board, reconnect the
MVT if disconnected,
and make field wiring
connections to the
expansion board.
Restore power to the
Scanner 2000 and
reboot the Scanner to
allow detection of the
expansion board.
4.
5.
CAUTION: FAILURE TO ALIGN PINS AND HEADERS
CAN DAMAGE THE BOARDS.
