CAME FLUO-SL, Сборка и инструкция по установке

Страница: 20 / 40

FA00150-EN v.7 - 06/2017 20 CAME S.p.A.
12.1 GENERAL SAFETY ELECTRICAL PRECAUTIONS
Installation, electrical connections and adjustments must be completed in conformity with Good Working Methods and with
regulations in force.
Before making power connections, check that the rating corresponds to that of the mains supply. A multipolar disconnection
switch with a contact opening gap of at least 3 mm must be included in the mains supply. This switch must be protected from
unauthorized activations.
Check that upstream of the electrical installation an adequate residual current circuit breaker and an overcurrent cut out are
fitted.
When requested, connect the automation to an effective earthing system carried out as indicated by current safety
regulations.
During installation, maintenance and repair operations, cut off the power supply before opening the cover to access the
electrical parts.
To handle electronic parts, wear earthed antistatic conductive bracelets. CAME S.p.A. declines all responsibility in the event
of components which are not compatible with the safe and correct operation of the product.
For repairs or replacements of products only original spare parts must be used.
12.2 POWER SUPPLY ELECTRICAL CONNECTION
Use the supplied cable for connection to electricity.
The power cable can be connected to an electric plug (not
supplied by us), arranged near the end cap of the
automation.
Drill a hole in the end cap area prepared, route the power
cord and secure it inside the end cap through the cable tie.
Note: file off the edge of the aluminum, so as to eliminate
sharp edges that might damage the power cable.
In case there isn't a socket near the automation, to perform the connection to the power supply in the following manner: drill
the aluminum profile in the upper part or in the rear wall fixing, protect the passage of the power cord through membrane
grommets or cable glands (not supplied by us) to eliminate sharp edges that might damage the power cable, and connect the
cable to the power supply.
The connection to the mains supply in the outer portion automation, should be an independent channel, separated from the
connections to control and safety devices.
12.3 TERMINAL OF ELECTRONIC CONTROL
Note: The terminals with the same number are equivalent.
The electronic control comes with the jumpers on the terminals with an asterisk [*]. When connecting safety devices remove
the jumpers of the corresponding terminals.