L
3
8
4
6
9
7
5
2
1
100 °
82 °
54 °
72 °
1÷9
0
J
J
PROG
M1
CN4
B
B
<1’’
<1’’
9
3
4
beep
beep
PROG
M1
CN4
B
B
>3’’
>3’’
<6’’
<6’’
1
2
+
5
1-2-3
1-2-3
K
12345
12345
beep
beep
6
+
+
P
age
13
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
13
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
13
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
Programming entry panel video cameras.
While programming the call keys the
“visual range” of the video camera can be adjusted from any receiver (with handset
raised, it there is one), by pressing the “Self-connection”
key
8
. From the default
settings it is possible to scroll through the following ones
K
by pressing the AUX1
key, or to go back to the previous ones with the AUX2 key
L
: the setting is saved
automatically.
Entry panel brightness level adjustment.
While programming the call keys the entry
panel brightness level can be adjusted from any receiver. Pressing the “Self-connection”
key on the receiver activates the video camera of the entry panel for which the bright-
ness level is to be adjusted. The brightness level can be increased/decreased by using
a previously assigned call key, or by simulating a call from DNA.
Reprogramming Procedure
Entering Programming Mode.
Press the PROG key
1
for at least 3 seconds and
release within 6 seconds. If the PROG LED immediately goes out it means there is a
malfunction. Check the connections and return to programming. The LEDS on the entry
panels light up as shown in fi gure
2
. Wait 5 seconds for the auto test to be completed
and continue as shown below.
Programming the call keys.
Press the door release
and AUX2 buttons
3
. On
the entry panel, press the call key to be linked to the receiver
4
: a beep will confi rm
that the setting has been stored. Continue, repeating the same operations for all the
other receivers.
Programming the door release code and relay with DNA.
Press and key in the
relay code you wish to programme (press key 1 to activate the door opening control in
the entry panel; press key 2 to activate relay 1 on the VLS/2 relay module; press key 3
to activate relay 2 on the VLS/2 relay module)
5
. Press once
again and key in the desired code (from 3 to 5 fi gures). Once
programming has been completed, by pressing the key plus
the desired code and it is possible to activate the door opening
control and relay 1 or 2
6
.
