stylo-BD:
GEOMETRY
Preliminary checks
Side hung gate GEOMETRY
Tick
1. Check that the gate structure is sturdy enough, the hinges work efficiently and that there is
no friction between the fixed and moving parts
2. Make sure that measurement
C
does not exceed the value shown in the reference table
3. Make sure that you have fitted opening and closing mechanical gate stops
Side hung gate GEOMETRY:
STYLO-ME / STYLO-BD
• The greater the motor angle, the greater
the opening speed and the slower the
gear motor’s thrust.
• The smaller the motor angle, the slower
the opening speed and the greater the
gear motor’s thrust.
Opening
A (mm)
C (mm)
D (mm)
90
°
90
0÷200
400
90
°
230
180
300
135
°
230
0
300
D
A
C
OUTward OPENING gates
For outward opening gate geometry
please refer to the full Installation Manual.
Secure the gearmotor to
the flange using the four
bolts supplied
Secure the upper cap
UNI 6954 Ø 3,9 x 9,5
O-Ring 2012
Securing the transmission arm
1. Assemble the slide guide to the transmission arm as shown in the drawing
(1).
2. Insert the guide into the rail (2).
3. Assemble the straight arm onto the gearmotor shaft (3). Cover the hole
with the cap and secure it using the supplied screws (4).
4. Insert the end caps of the rail and the hole covers (5)
Ø 3,5 x 9,5
Remove the lower cap
from the gearmotor
