CAME 806SS-0050, Руководство по установке

Страница: 10 / 20

FA01695M4A - 06/2022 FA01695M4A - 06/2022
Technical data
Type RIOCT8WS
Power supply (V) 24 AC/DC
Current draw (mA) 80 max.
Relay contacts 24 V max. (A) 1
Radio range over clear areas (m) 30 max.
Storage temperature (°C)* -25 ÷ +70
Average product life (cycles)** 100,000
Frequency (MHz) 868.95
(*) Before installing the product, keep it at room temperature where it
has previously been stored or transported at a very high or very low
temperature.
(**) The average product life is a purely indicative estimate. It applies
to compliant usage, installation and maintenance conditions. It is
also infl uenced by other factors, such as climatic and environmental
conditions.
Installing
⚠ Before continuing, cut off the MAINS POWER SUPPLY and
disconnect any batteries.
Fitting the casing and control card
- Use a drill to perforate the marked holes needed for the cables to pass
through
① .
- Fasten the casing, using plugs and screws suitable for the surface.
- Fit the card and slide it along its guide.
NB: Do not change the antenna's position.
- Once the cables are laid (see example in
figure
C), power up the
automation and check that the WIRELESS LEDs are fl ashing. If they are
not fl ashing, RESET the card (see the corresponding procedure).
- Remove the batteries from the accessories.
- Save each and every component of the system (see accessories
instructions).
Make the required functional checks (see the corresponding procedure),
close the cover and fasten it to the base by using the supplied screw.
② .
Description of the terminal board
10-2
Power supply input 24 V AC/DC ⑬
10-E
Flashing light input 24 V AC/DC ⑭
TS Safety-test input
(
if unused, bridge with 2 ) ⑯
IN1 - IN2 Not used
OUT1 (NC) Output activated by IN1 input on the RIOED8WS
saved with T1
OUT2 (NC) Output activated by IN2 input on the RIOED8WS
saved with T2
OUT3 (NC) Output activated by RIOPH8WS saved with T1
OUT4 (NC) Output activated by RIOPH8WS saved with T2
OUT5 (NC) Not used
LAMP-230 V Flashing light input at 230 V ⑮
⚠
You cannot simultaneously connect the fl ashing lights to the 24 V
AC/DC and
⑭
230 V AC inputs
⑮
.