Camco Q-Power 10, Руководство пользователя

Страница: 16 / 36

2+ 1+ 2- 1- 2+ 1+ 2- 1-
A
B
C
D
2+ 1+ 2- 1- 2+ 1+ 2- 1-
D C B A
-
+
3 INST
ALLA
TION
USER MANUAL
Q - P O W E R S E R I E S
P. 14
Q - P O W E R
S E R I E S
The pin confi guration of the Barrier Strip connector is as follows:
Top row from left to right:
(all ) Channel D - Channel C - Channel B - Channel A
Bottom row from left to right:
(all signal -) Channel D - Channel C - Channel B - Channel A
The Q-POWER 6 and Q-POWER 10 amplifi ers are optimised for a loudspeaker
impedance of 4
Ω
. Attaching lower impedances might affect audio quality and
overall performance of the amplifi er.
To connect any custom speaker cable wiring to the Barrier Strip connectors re-
move the security cover which is held by two screws. Take care to reinstall the
security cover after all connections are made, and be cautious to avoid short-cir-
cuits between the speaker wires and the security cover or chassis (for example
due to damaged or clamped cable isolations).
NOTE / IMPORTANT:
The Q-POWER 10 uses a bridged power amplifi er output stage. This implies
that the amplifi er outputs will not be referenced to ground. Please make
sure to always attach the loudspeakers between the and the
signal - pins of the same channel on the SPEAKON or Barrier Strip connec-
tors.
Any damage to the loudspeaker or amplifi er due to wrong cabling and/or
inter-channel short circuits will not be covered by warranty.
For reasons of safety and performance, only use high-quality fully in su lated
speaker cables of stranded copper wire. Use the largest wire size that is eco-
nomically and physically practical and make sure that the cables are no longer
than necessary.
WARNING !
SPEAKON connectors marked with the lightning fl ashes indicate high vol-
tages that are potentially life threatening.
Wiring to these terminals requires installation by an instructed person or
the use of ready-made leads or cords.
Custom wiring should only be carried out by qualifi ed personnel.
To prevent electric shock, do not operate the amplifi er with any of the con-
ductor portion of the speaker wire exposed.