Assembly Instructions For The Cedar Glider And Glider Chair
Tools Needed:
Hammer For Light Tapping
Screwgun
#2 Square Drive Bit
Parts List:
Seat Assembly ( 1)
Back Assembly (1)
Right Leg Assembly (1)
Left Leg Assembly (1)
Foot Assemblies (2)
1 x 4 Braces (2 )
Step 1
Lay out and identify all the parts and pieces.
Hardware:
1/4 • x 4-3/4" Bolts (2)
1/4 • x 2-3/4" Bolts (4)
1/4" x 2' Bolts (2)
1/4., x 1-3/4
°
Bolts (8)
2-1/2" Screws (10)
Glider Hangers ( 4)
Allen Wrench (1)
Step 2
Fasten the back to the seat. Align the predrilled holes on the bottotn of the back with the threaded
inserts in the back of the seat. Put two 4-3/4" bolts down through the back & turn into the inserts
in the seat with the Allen wrench. NOTE: Do not fully tighten these bolts until Step 3 is
completed.
Step 3
Take an ann assembly and align the predrilled holes in the legs with the threaded inserts in the
side of the seat. Insert two 2-3/4' bolts and semi-tighten. Now align the predrilled hole on the
back of the arm with the threaded insert on the side of the back assembly. Insert a 2'' bolt and
tighten with the Allen wrench. (The back assembly can be moved back & forth if the holes don't
align properly). Attach the other ann assembly and tighten all bolts.
Step 4
Now the frame that goes lllldemeath the glider seat needs to be assembled. Take the glider feet
and set them on the floor. (The slight arch is on the bottom, with the long flat edge being the
top). Take the lx4 braces and attach them to the top edge of the blocks on the inside of the glider
feet with the selfdrilling screws. The braces are fastened on the outside of the blocks. (See photo
below). Put two screws in each end of the lx4. (Extra screws are provided). Once base is
assembled turn base so that metal
inserts
that are
closest to front
edges
of
glider
feet
are
turned
toward the front.
Step S
Now attach the glider hangers to the leg assemblies. Put the hanger on the inside of the leg &
align the hole in one end of the hanger with the threaded insert on the bottom of the leg
assembly. Put a 1-3/4" bolt through the glider hanger & tum into the insert in the leg. Tighten
with the Allen wrench. Attach the other hangers the same way.
Step 6
Set the glider on top of the frame. Now ali
gn
the other hole in the glider hanger with the threaded
insert on the top edge of the glider foot. Put another 1-3/4" bolt through the glider hanger, tum
into the insert & tighten with the Allen wrench. Attach the other hangers the same way.
Содержание 1600
Страница 1: ......
