Cambridge Sensors microdot, Руководство по эксплуатации

Страница: 14 / 31

TESTING WITH PATIENTS
What You Do
Notes
3.
Apply sample.
4. Results in
10 seconds.
5. Dispose of
lancet.
The blood drop symbol will flash
alternately to indicate the meter has
detected that a test strip has been inserted
and is ready for the blood sample to be
added.
Apply the drop of blood directly to the
edge of the test strip, and allow the sample
to wick automatically into the test zone.
If you do not apply a blood sample within
one minute, the meter will turn itself off.
Either reinsert the test strip or press the
M button to turn the meter back on.
After an adequate blood sample has been
applied to the test strip, the Microdot®
Xtra Meter will display three running
dashes, which indicates the meter is
performing the test. After 10 seconds,
the test result will display.
Dispose of used lancet in an approved
sharps container.
6.
Dispose of
test strip.
Simply press the eject button on the
meter to dispose of used test strip.
Note: If the blood test result is lower than 20 mg/dL,
“Lo” will appear on the meter display.
This indicates severe hypoglycemia
(low blood glucose). You should
immediately treat your hypoglycemia
as recommended by your physician’s
protocol. If the blood test result is higher than 525 mg/dL,
“Hi” will appear on the meter display.
This indicates severe hyperglycemia
(high blood glucose). You should
immediately treat your hyperglycemia
as recommended by your physicians
protocol.
Chapter 4
12
Cambridge Sensors USA, LLC
BLOOD GLUCOSE MONITORING SYSTEM
LOG SHEETS
The forms in this chapter are Master Copies .
Please make photocopies for distribution.
If you need replacement documents, please
contact Customer Service at (877) 374-4062
Chapter 7
15
Cambridge Sensors USA, LLC
®