.
Remove the round cardboard pad from inside
the supplied template .
(4.1”)
(0.39 - 1.18”)
Min 10-30mm
Min 105 mm
Use the template to mark the position for the
mounting hole at the selected location.
Before cutting ceiling speaker holes, it is suggested that the area is tested
for clearance by making an L-shaped probe from strong wire (see illustration
below), drilling a small hole in the target area, inserting the probe and slowly
turning. Any obstructions will be immediately obvious, and the target area can
be moved to a more suitable position.
Before mounting, ensure that the four fixing screws are slackened off so that the
red mounting dog-legs can move freely.
Move each red dog-leg foot to the LEFT into it’s holding slot, and then insert the
speaker into the mounting hole.
Using a cross-head screwdriver, slowly turn each fixing screw clockwise. This will
move the mounting dog-legs out of their slots.
Tighten each fixing screw until the mounting dog-legs grip the ceiling.
Connecting
Do not compromise the performance of your system by using inferior quality speaker
cables. We recommend that high quality cables of 16 gauge or higher be used.
Your professional dealer will give you good advice. Always unplug all A.C. powered
components before making any loudspeaker or component connections. This will
avoid the risk of electric shock or damage to your equipment.
Follow these steps to connect the speaker to your amplification system:
Route the speaker cable from your amplification system to the speakers.
n
Avoid routing the speaker cable near electrical wires
n
Do not nail or staple the cable
Separate about 100mm of speaker cable at each end.
Using a wire stripper, remove about 10mm of insulation from both ends of
each conductor, and then twist the strands of each conductor .
Observing polarity is of the utmost importance while connecting your
speakers. Ensure that the red (+) terminals on your amplification system are
connected to the red (+) on the speakers, and black (-) on your amplification
system to black (-) on your speakers.
We recommend use Minx C46 Satellite speaker connect to the SAT on the C200B.
The speaker cable is coded with a bead or stripe down one lead’s insulation, or has
differently coloured wires.
Press the spring-loaded red or black tab back to reveal the connecting hole. Insert
the stripped end of the speaker wire, then release the tab.
. If your speakers are wired incorrectly they will be out of phase and sound
hollow and indistinct, with a weak bass. Re-check your connections for cor-
rect polarity and reverse the connections if necessary.
Mounting
123mm
(4.84”)
123mm
(4.84”)
246mm diameter mounting hole
Cut the mounting hole with a drywall or
keyhole saw.
Be sure the mounting surface is between 10 and 30mm(0.39 - 1.18”) thick,
and that there is at least 105mm(4.1”) of clearance behind the mounting
surface.
By reason of the magnet, we can remove grille by our finger easily , be careful, Fit
the clear plastic painting mask provided when painting the speaker surround to
avoid getting paint getting on the speaker cone.
PAINTING THE FRAME AND GRILLE
1
1
3
2
4
5
2
3
10mm
100mm
-
-
SAT
IN
IN
-
SAT
-
Please check with your builder/installer whether
you need to install a fire hood with this product.
“Low smoke/zero halogen” specification Speaker
cable may also be required.
(FH20 Optional accessories)
Satellite speaker
(Minx C46)
Satellite speaker
Minx C46
AP337571 CA0808 C200B CEILING SUBWOOFER INSTALLATION GUIDE.indd 2
8/20/14 11:18 AM
