background image

SERVICING 

These units are not user serviceable, never attempt to repair, disassemble or 

reconstruct the unit if there seems to be a problem. A serious electric shock could 

result if this precautionary measure is ignored. In the event of a problem or failure, 

please contact your dealer.

FEDERAL COMMUNICATIONS COMMISSION

Supplier’s declaration of conformity (SDoC)
Equipment(s): Stereo Receiver 

Model(s): AXR85,AXR100 

Trademark: Cambridge Audio
This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that 

may cause undesired operation.
The responsible party in US:
Company name: Audio Partnership LLC                       
Address: 1913 N Milwaukee Ave. Chicago, IL 60647 
Phone: (312) 636-4817 

Legal Representative Person: Gregg Chopper

Signature:

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) this device may not cause harmful interference, and (2) 

this device must accept any interference received, including interference that may 

cause undesired operation.

FEDERAL COMMUNICATIONS COMMISSION NOTICE:

This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation.

This equipment generates, uses, and can radiate radio frequency energy, and if 

not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged 

to try and correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the distance between the equipment and the receiver.

•  Connect the equipment to an outlet on a circuit different from that to which the 

receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: Any changes or modifications not expressly approved by the party 

responsible for compliance could void the user’s authority to operate this equipment.

RF EXPOSURE STATEMENT:

To maintain compliance with FCC’s RF Exposure guidelines. This equipment should 

be installed and operated with a minimum distance of 20cm between the radiator 

and your body. Use only the supplied antenna.

MODIFICATIONS:

The FCC requires the user to be notified that any changes or modifications to this 

device that are not expressly approved by Cambridge Audio, may void the user’s 

authority to operate the equipment.

CANADA-INDUSTRY CANADA (IC)

This radio transmitter has been approved by Industry Canada.

This device complies with Industry Canada's license-exempt RSSs. 

Operation is subject to the following two conditions.

(1) this device may not cause interference and (2) this device must accept any 

interference, including interference that may cause undesired operation of the 

device.

This equipment should be installed and operated with a minimum distance of 20cm 

between the radiator and your body.

The transmitter must not be co-located or operating in conjunction with any other 

antenna or transmitter.

The device meets the exemption from the routine evaluation limits in section 2.5 

PLUG FITTING INSTRUCTIONS (UK ONLY)

The cord supplied with this appliance is factory fitted with a UK mains plug fitted 

with a 5 amp fuse inside. If it is necessary to change the fuse, it is important that 

a 5 amp one is used. If the plug needs to be changed because it is not suitable for 

your socket, or becomes damaged, it should be cut off and an appropriate plug fitted 

following the wiring instructions below. The plug must then be disposed of safely, 

as insertion into a mains socket is likely to cause an electrical hazard. Should it be 

necessary to fit a 3-pin BS mains plug to the power cord the wires should be fitted as 

shown in this diagram. The colours of the wires in the mains lead of this appliance 

may not correspond with the coloured markings identifying the terminals in your 

plug. Connect them as follows:
The wire which is coloured BLUE must be 

connected to the terminal which is marked 

with the letter ‘N’ or coloured BLACK.
The wire which is coloured BROWN must be 

connected to the terminal which is marked 

with the letter ‘L’ or coloured RED.
The wire which is coloured GREEN/YELLOW 

must be connected to the terminal which is 

marked with the letter ‘E’ or coloured GREEN.
If a 13 amp (BS 1363) plug is used, a 5 amp fuse 

must be fitted, or if any other type of plug is 

used a 5 amp fuse must be fitted, either in the 

plug or adaptor, or on the distribution board.

of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian 

information on RF exposure and compliance.

INDUSTRIE CANADA (IC)

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux 

appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions 

suivantes :

(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit 

accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible 

d’en compromettre le fonctionnement.

Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le 

radiateur et votre corps.

L’émetteur ne doit pas être co-placé ni fonctionner en conjonction avec une autre 

antenne ou transmetteur.

Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 

2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir 

l'information canadienne sur l'exposition et la conformité de rf.

EUROPE-EUROPEAN UNION NOTICE

Hereby, Audio Partnership PLC declares that this product is in compliance with 

Directive 2014/53/EU, the full text of the EU declaration of conformity is available at 

the following internet address: 

https://www.cambridgeaudio.com/DoC

Bluetooth Radio Frequency:  

2.402 GHz-2.48 GHz  The Max. transmit power: 10dBm

Содержание AXR85















Отзывы: