Chapter 6: Configuration and alignment
System menu
Page 6-50
Procedure:
1 Review and update the attributes: IP Interface (
Bridging (
2 To save changes, click Submit Updated System Configuration. The system may reboot.
3 If Main PSU Port is selected for Data Service only (and not for Management Service), connect
management PC to the port (Aux or SFP) that was selected for Management or Local
Management Service
4 If IP Address, Subnet Mask or Gateway IP Address have been changed, reconfigure the local
management PC to use an IP address that is valid for the network. Refer to
5 If IP Address has been changed, use the new IP address to log into the unit.
Table 160 IP interface attributes
Attribute
Meaning
IP Version
IPv4 Address
Subnet Mask
Gateway IP Address
IPv6 Address
IPv6 Prefix Length
IPv6 Gateway Address Defined in
IPv6 Auto Configured
Link Local Address
Use VLAN For
Management
Interfaces
VLAN Management
VID
VLAN Management
Priority
DSCP Management
Priority
Data Service
Second Data Service
Management Service
Содержание PTP 670 Series
