Cambium Networks PTP 850E, Руководство пользователя

Страница: 339 / 560

Chapter 14: Radio Configuration (CLI) Configuring and Viewing Radio PMs and Statistics (CLI)
phn-3963_008v000
Page 14-9
Table 74 RSL and TSL PMs (CLI)
Parameter Description
Interval The number of the interval: 1-30 for daily PM reports, and 1-96 for 15 minute
PM reports.
Integrity Indicates whether the values received at the time and date of the measured
interval are reliable. "1" in the column indicates that the values are not
reliable due to a possible power surge or power failure that occurred at that
time.
Min RSL (dBm) The minimum RSL (Received Signal Level) that was measured during the
interval.
Max RSL (dBm)
The maximum RSL (Received Signal Level) that was measured during the
interval.
Min TSL (dBm) The minimum TSL (Transmit Signal Level) that was measured during the
interval.
Max TSL (dBm) The maximum TSL (Transmit Signal Level) that was measured during the
interval.
TSL exceed
threshold seconds The number of seconds the measured TSL exceeded the threshold during the
interval. See
Configuring TSL Thresholds (CLI) .
RSL exceed
threshold1
seconds The number of seconds the measured RSL exceeded RSL threshold 1 during
the interval. See
Configuring RSL Thresholds (CLI).
RSL exceed
threshold2
seconds The number of seconds the measured RSL exceeded RSL threshold 2 during
the interval. See
Configuring RSL Thresholds (CLI).
Configuring the Signal Level Threshold (CLI)
To set the BER (Bit Error Rate) level above which a Signal Degrade alarm is issued for errors detected over the radio
link, enter the following command:
radio [x/x]>modem signal-degrade set threshold 1e-7
To display the Signal Degrade BER threshold, enter the following command:
radio [x/x]>modem signal-degrade show threshold